Audio Amp TDA2003

5,572

56

6

The TDA 2003 hasimproved performancewith the

same pin configuration as the TDA 2002. The additional features of TDA 2002, very low numberof externalcomponents,ease of assembly, space and cost saving, are maintained. Thedeviceprovidesa high outputcurrentcapability (up to 3.5A) very low harmonic and cross-over distortion. Completely safe operation is guaranteed due to protectionagainst DCand ACshort circuit between all pins and ground,thermal over-range,load dump voltage surge up to 40V and fortuitous open ground.

Step 1:

The main means of doing this are magnifying these:

  1. TDA2003
  2. Resistor 20k
  3. Capacitor 1000 uf,25v
  4. Capacitor 2.2uf,50v
  5. Copper board

Step 2:

Copper plate then we do the voice connection magnifier.

Then place the electronic components and begin to capture them in certain places and tin soldering . I noticed that created one of 10w amp

Share

    Recommendations

    • Arduino Contest 2019

      Arduino Contest 2019
    • Party Challenge

      Party Challenge
    • Classroom Science Contest

      Classroom Science Contest

    6 Discussions

    0
    None
    bscgvrvr

    3 years ago

    where is the power supply to this amplifier?

    1 reply
    0
    None
    maximzodal

    3 years ago

    Not really an instructable with no circuit diagram!

    0
    None
    bscgvrvr

    3 years ago

    where is the power supply to this amplifier?

    0
    None
    martin365

    3 years ago

    what does this device do?