Mini Quad Rebuild on Laser Cutter( Hubsan X4 )

1,870

36

1

Ok so i made this Quad frame from card-bord that was going to the trash at Fablab in Odense. i used the lasercutter at the lab to cut the frame in to 2D pices, glue them on top. and lust fit in the elektroniks and you are up in the air as cheap as it get's... freebii!!!!!!

hop it can inspirer you.

thanks to http://www.fablabinnovation.dk/(Fablab Odense ) for the gurilla workshop on Onsdag from 10-18

that is for this time, until we're back.

Share

    Recommendations

    • Arduino Contest 2019

      Arduino Contest 2019
    • Classroom Science Contest

      Classroom Science Contest
    • Fandom Contest

      Fandom Contest

    Discussions