Gunflint Designs

Thanks! They loved it.

Thank you very much, I really appreciate that!

Thank you! I'm glad you're enjoying my stuff,

It is a safe and very precise way of making crosscuts on a table saw. It also allows you to repeatable cuts of an exact length if you need multiple pieces of something. You can just clamp a drop block at whatever length you need to the rear fence and butt your workpiece up against it. Then just make a cut, slide the workpiece over and make another cut. It results in identical pieces and you only had to measure one.

Thank you very much. And yes I do. I've been at this for about 2 years now, been trying to take it pretty seriously for since just last year.

Thanks KJ! I had a smaller one when I had my smaller saw. The ideas definitely scale well with whatever equipment you have.

Haha! I think that was just some clearance rack thing from WalMart.

I have a video on my YouTube channel on how I made my pressure tune. But if you don’t like that route, there are lots of other resion options that could work without it.

I have a video on my YouTube channel on how I made my pressure tune. But if you don’t like that route, there are lots of other resion options that could work without it.

Thanks for the information! If that finish starts to bug me too much I’ll have to give it a shot.

Hey, thanks for the feedback Michael! I honestly wasn’t THAT concerned about it for personal use. But after talking to the manufacturer and knowing I’d be sharing this with the world, I figure I’d take the ‘better safe than sorry’ approach.

Thanks! I’m glad you like it.

Thank you! Was definitely going for clear and inspirational.

It’s definitely a subtle flaw that turned into an accent!

Thank you, I really appreciate that! Seems like a great community here and I'm excited to be a part of it.

Haha, finally? Have you been waiting for me?