I have high frequency hearing loss and tinnitus, so I can't hear hear any chirping from a bird at all, but maybe someone else that reads the comments/questions will be able to help out there.As for the jig, I'm not sure if there is a tubular version, because of removing it and putting such a knot in place for final tightening might be an issue, but you might ask on one of the turk's head knot related groups on facebook, to see if someone there might have answers/suggestions... ;)
Great looking shelf, thanks for sharing! :)
It might be possible to carefully cut some holes/slots in the band just below the quick release system part, allowing you to anchor your paracord to it, much like a side release buckle. I've not tried that myself, so I'd recommend maybe practicing with a scrap piece of material to see what would work best, like individual holes or a pair of slots ...
Finishing Paracord Ends...View Instructable »
Yes, a 3/8" buckle will work with this project.
The ITW Nexus buckles (various sizes/models) are my favorite, but they're quite a bit more expensive than the many cheaper imported versions, which work well enough for most folks, so it comes down to what you want to spend. Some folks only want actual mil-spec paracord instead of the cheaper quality commercial paracord, and they don't mind spending twice as much for it, again it just comes down to your choice. ;)
It can take time to untie/unravel a knotted paracord bracelet, and the cord will probably be kinked up, and may be dirty/worn and weakened depending on how hold it is and how often it has been carried, but can still be useful if needed. There are many different possible designs for paracord bracelets, some use patterns than can come undone quickly, like a chain sinnet. Considering that many paracord bracelet designs use around 10 feet of cord, some more, some less, if someone has an urgent speedy emergency need for that small amount of cordage, then their problem probably is beyond a basic utility need that length of cord might assist with... ;)
Width will vary by the actual cord you use, and paracord can vary in thickness/width of the strand from one manufacturer to another, and how tight or loose you tie the bracelet/watchband. The tan one in my photo has a tied width of about 7/8" thick.
Maybe. It would depend on how flexible the wire is.
Different gauges of wire are often used for jewelry making (braided/twisted/knotted/knitted). The thinner wire is usually more easily bent and worked where the thicker it gets may require tools to bend and twist it into shape.
For watches with thinner attachment sections, I've used gutted paracord, and done two piece watchbands to work with those type watches. You just have to experiment with different paracord designs and options base on the variety of watches out there.