Hi Francisco,The instructions are for naze32 rev6You should not confuse between the version of the hardware (Naze32) and the firmware (Cleanflight).There is longtime that we didn't update the firmware of our drone, so we didn't tried the new versions of cleanflight, I don't know the changes but I suppose that the main configuration should be the same.However, the community is moving to betaflight, that looks is improving a lot. Please if you configure the with this version could you post here your configuration?Hope you will arrive to configure properly.
Hi Rinzin, Everything that you need to order is in this post:http://flone.cc/comprar-flone/Is in spanish but below you have the table with all the links.Is easy to install the firmware, is a standard cleanflight installation.
Yes, is 300 x 300 mm
We are still doing different projects with flone hardware and software.We mainly publish our activity in flone facebook page:https://www.facebook.com/floneflyingphone/
Yes, sorry, depends of the software when you open it can change the dimensions, you should always check the right scale 300 x 300.You should glue it below the frame, placing inside the xt60 connector.If you have more questions please use our forums:http://forum.flone.ccRegards
Voice Controlled Arduino Drone
Flone 3.0 Drone Quadcopter
Flone Quadcopter Transportation Box
Laser Cut MultiWii based quadcopter