Tell us about yourself!
Arduino Mini CNC Plotter Machine From Dvd Drives
Easy to Build Desk Top 3 Axis CNC Milling Machine
DIY 3D Printed Dremel CNC
DIY - USB OSCILLOSCOPE IN a MATCHBOX
DPScope SE - the Simplest Real Oscilloscope/logic Analyzer on the Planet
Arduino Based Wireless (RF) Weather Station Network
DIY Mini UPS for WiFi Router / Modem
How did you make the calculations for the resistors before 4N25?
Wireless Remote Using 2.4Ghz NRF24L01 Module With Arduino | Nrf24l01 4 Channel / 6 Channel Transmitter Receiver for Quadcopter | Rc Helicopter | Rc Plane Using Arduino
How to Build 8 Channel Transmitter Nrf24l01 Arduino
NRF24L01 RC Transmitter
Can you give us more details about heater controller ?
About the wave cycles and the sync with the AC from the plug
DIY SMD REWORK STATION.
1:26 Scale Diesel Engine Modell
Do you believe that a 3D printer can make an HO scale model with good result?
From Pickit 2, the hex's configuration bits areFBS 000FFSS 0000FGS 0007FOSCSEL 0003FOSC 00E2FWDT 005FFPOR 0000FICD 0083Are they correct?
I have built the circuit and when i program the pic with my Pickit 2 i receive a warning, "Some configurations words not in hex file. Ensure defaults values above right are acceptable"Do i have to do something?I continue and program the pic with success. Also when i power it on, i connect both BNC cables signal to ground and i am getting a measure +1.57V in both channels. Otherwise (not connected) the measure is +4V. Is that correct? Do i have to remove it from the offset? Is there any calibration method?I haven't test it yet.Thank you!
Thank you for the answer. Is there, approximately, a value for this signal ?Can you give me an example with values ?
"Analog bandwidth (Large Signal), 0.30/0.30/0.70 MHz ,For Gain 1/2/5 Analog bandwidth (Small Signal), 12/6/7 MHz ,For Gain 1/2/5"What do you mean, Large Signal or Small Signal ?Thank you!Vasilis