Tell us about yourself!
Hello,I do not have any picture.I gave the device to my father :)But I have references : Difema Ultra Soude 230M 220 / 320V.
Iron Washer ValetView Instructable »
Hello,For the desk I used a 60led/m.
Here an idea for Iron man : http://maiss-thro.deviantart.com/art/The-Invincibl...Yes Iron man, like Tron motorbike could make a very good desk :)
Thank you for suggestion.I don't use a guide but it was a mistake, if I have to remake it, I will...
Hello,Yep, it was hard and so stressfull :)
Hello,You are right, a plan is missing. I had one in the step 2. I hope it will respond to your question :)Yes there is Two planks : Top with resin and botton with Led. Like this, is led are break I could easily change it.For non-stick backer I use "baking paper" (not sure of this word...=> "papier cuisson" in french) => http://www.thiolat.com/medium/69_height-350-render...
Thank you for your comment :)
Make a Led Tron Desk and Le...View Instructable »
Thanks :)The most difficult is to make the cooper egg. I think you can use a 0.3 mm copper plate instead of the 0.5 mm plate.It will be easier to make the egg and robust enough to welding scales.The 0.5 mm copper plate was good but a little too rigid.Perhaps with 0.3 mm there is no need to anneal the plate...just need a good hammer :)
See here :)
Yes I make it myself!But unfortunatly I didn't take photo of the process. I realize at the end that I can post the process :(If you doubt, try to find on internet a cooper egg with a 30 cm flat ruler, or a cement egg print :)
I dont't know... :p